Pages

Simplest Transformerless LED Drivers

In this post we learn regarding three interesting transformerless power supply circuits for illuminating LEDs from mains that uses minimum number of components


Circuit 1


Simplest Transformerless LED Drivers


A capacitor must be having a rating of more than 200V and should be having dialectic of metallize polyester or poly poplin.

A resistor 1K is employed to limit the in rush current the resistor should be having the wattage value of more than 1Watt.

A diode is connected in anti-parallel to the LED. This diode limits the reverse voltage across the LED. The diode also provides the path for the negative half cycle as the LED is connected to a AC power source.

This particular circuit behaves like a constant current source of 15 to 20mA depending on LED voltage bias and supply line stability with a nominal 60Hz power supply frequency. The circuit 2 is an improvisation over circuit 1 and it enables to glow two LED’s at a time. This gives a color benefit also.

Putting two switches to the series part of individual LEDs can enable the viewer to have three colors.

In this transformerless circuit using the above formula the current can be manipulated by changing the capacitor value. Power LEDs can also be driven directly from AC power source.

Circuit2



Simplest Transformerless LED Drivers


The third circuit employs a zener diode of 5.6 V/1W. The zener diode serves dual purpose. Firstly it acts as a bias of the negative half of circuit like the diodes employed in circuit 1 and 2. Secondly, it acts as a voltage regulator for the LED driver circuit.

This circuit provides 5 Volts steady output with a 30mA current pumping facility. The 1000uF capacitor acts as a ripple suppressor and it allows a moderate ripple of 6% that is 300mV in this case. Employing the third circuit the use can expect better life of the LED. The current limiting capacitor used is 1.5uF at 200Volts.

The capacitor supplies the current to the driver as well it biases the zener to remain active during operation.

Please note that while using any LED it's datasheet should be studied beforehand. In general natural white LEDs, cool white LEDs, warm white LEDs all have a nominal bias voltage of 3.5V DC. But the activation starts at 2 to 2.4V DC.

The highest efficiency of the LED is achieved at 3.5V DC. Optimization of power supply is the highest priority in any LED driver circuit.

Circuit 3


Simplest Transformerless LED Drivers


If a constant voltage supply is provided it is to be notes that the power supply must have minimum ripple content.

The peak of the ripple shall also effect the performance of the LED so far as the junction temperature of the wafer is concerned. However a constant current source is a safest power supply alternative for a LED. A constant current source can achieved in many ways.

A variable power supply that is regulated by a current loop is the general trend. A capacitor in series is obviously the most economic constant current source so far as AC power supply is concerned.

Any fluctuation in the input power might result into the change in the current value,for this purpose,a regulator like 5.6 V zener is a safe practice.

While connecting the LED to the regulator circuit the power capacity of the regulator is to be kept in the mind along with the power requirement of the specific LED.

No comments:

Post a Comment

 
Blogger Templates