Pages

How to Make a Remote Control Circuit from a Remote Bell Unit

The proposed remote control circuit idea can be used for controlling any electrical gadget within a range of 100 meters. Since the idea here is to modify an existing circuit of a remote bell unit, becomes super easy without any complications.
However the construction part does require the involvement of electronic assemblies so this project may not be considered entirely a layman’s project.


We all have seen and probably used remote bell gadget in our homes. The device is basically a wireless RF receiver and a transmitter set which can be used for producing alarm sounds remotely for calling or indication proposes.


These gadgets are pretty effective with their functions and the specified operations are done efficiently across a considerable distance.


The Chinese made remote bell units are best suited for the proposed project.


Basically, when the transmitter of the remote bell is pressed, it sends a strong RF signal over a radial distance of approximately 100 meters.


The receiver unit positioned anywhere within this limit instantly plucks the trigger and switches the in built musical bell, sounding the alarm. The trigger may last for a few moments even after the transmitter is switched OFF.


The only feature that we are interested in is the effective transmission and receiving of the RF signals across the said distance.


If we are able to mod the receiver part of the unit so that the received trigger can be used to operate a relay instead of the usual alarm, our job is done.


However before we indulge into the modification process, it would be necessary to make the Flip Flop circuit first, which would be later on required to be integrated with the receiver set of the remote bell.


The flip flop section is a very simple configuration consisting of just a single IC and a few other passive components. The entire circuit may be buikt over a small general purpose board with the help of the shown schematic.


Circuit Diagram



How to Make a Remote Control Circuit from a Remote Bell Unit



 
Modifying the Receiver of the Remote Bell

On opening the cover of the remote bell receiver unit, the following things may be traced out for commencing the modding process:


You will find a small speaker connected via a couple of wires which terminate from the circuit board of the unit. Just cut-of the wires from the speaker, remove the entire circuit from its housing and screw it inside a new housing, which should be relatively bigger in size so that it can accommodate the flip flop section, the transformer power supply section and also the relay assembly.


After locating the negative wire out of the two speaker wires, integrate them to the flip flop circuit appropriately as shown in the figure.


Once the connections are made as per the schematic, check the system by powering the unit and by making a few triggers via the transmitter module.


The relay can be seen toggling in response to each subsequent triggers made by the transmitter module.


Your RF remote control circuit is ready and may be used for controlling any electrical gadget that you may prefer, wireless , across a radial distance of around 100 meters.

Parts List for the Circuit Diagram

The following listed parts will be required for making the above explained RF remote control circuit's flip flop section:



R1, R3 = 100 ohms,
R2 = 100K,
R4 = 4K7,
R5 = 10K,
C1, C2, C4= 22uF/25V,
C6 = 4.7uF/25V,
C3 = 0.1, CERAMIC,
C5 = 1000uF/25V,
T1 = BC557B
T2 = BC547B,
ALL DIODES ARE = 1N4007,
L1 = 50 turns of 30 SWG super enameled copper wire wound over a any ferrite material.
IC1 = 4017,
IC2 = 7805,
TRANSFORMER = 0-12V/500mA,






 

No comments:

Post a Comment

 
Blogger Templates